Knowledge base · Beginner help

Why won't my first layer stick to the bed?

By the 3D Printer Guide teamChecked

Most often: a greasy plate or the nozzle set slightly too high. Clean the build plate as your printer's maker recommends, then re-run the printer's calibration before changing any slicer settings.

Work through these in order

  1. Clean the plate. Skin oils stop PLA sticking.
  2. Re-run calibration or adjust Z offset. If lines look round and sit on top of the plate, the nozzle is too high. Printers such as the Prusa MK4S calibrate the first layer automatically with a loadcell.
  3. Check temperatures. Prusa lists a 40–60 °C bed for Prusament PLA and 80 ± 10 °C for Prusament PETG. Use your own filament's figures.
  4. Use the right surface. Prusa lists PEI, glass, painter's tape and glue stick as surfaces for both.
  5. Stop draughts. Close windows near the printer while the first layers go down.
  6. Add a brim in the slicer for small or tall parts.

Full walkthrough: first print checklist.

Sources

Opened and checked on 15 November 2026.