Affiliate links: some links on this page go to Amazon UK. As an Amazon Associate we earn from qualifying purchases. You do not pay more, and it does not change what we write. How this works.

Knowledge base · Filament

Does PLA need drying?

By the 3D Printer Guide teamChecked

Not always. Fresh PLA straight out of a vacuum-sealed bag usually prints well. Dry it when it shows signs of moisture, and store opened spools sealed so you need to dry it less often.

Signs PLA needs drying

Popping or hissing at the nozzle, extra stringing, rough or bubbly surfaces, or brittle filament that snaps on the spool. These can have other causes, so our sister site's is my filament wet? checklist helps you rule them out.

How it arrives

Many brands dry and vacuum-seal PLA before sale. Overture, for example, says on its listing that each spool is dried for 24 hours and vacuum-sealed.

Some materials need it far more

Nylon is much more demanding: Prusa recommends drying its PA11 at 90 °C for 6–8 hours if you are unsure how long the bag has been open.

See storing and drying filament and best filament dryer UK.

Sources

Opened and checked on 15 November 2026.